Parameter block layout
Description of the parameter block (metadata)
Eros3/ESR data format
Data is recorded in the matlab4 data format and consists of several blocks:
1 32m ESR
2 42m ESR
3 VHF
4 UHF
5 Kiruna
6 Sodankylä
8 32p ESR
0 SPEAR all tx off
1 SPEAR low power radar
2 SPEAR high power radar
3 SPEAR heating
0 Lower plasma line LO1 set to 492 MHz and upper plasma line LO1 to 502 MHz
1 Lower plasma line LO1 set to 496 MHz and upper plasma line LO1 to 502 MHz
2 Lower plasma line LO1 set to 492 MHz and upper plasma line LO1 to 506 MHz
3 Lower plasma line LO1 set to 496 MHz and upper plasma line LO1 to 506 MHz
Bit 0 UHF RF on
Bit 1 UHF HV on
Bit 2 UHF power on
Bit 3 VHF RF on
Bit 4 VHF HV on
Bit 5 VHF power on
Bit 6 Heating RF on
Bit 7 Heating power on
bit 0:1 Antenna phasing
0 allB
2 allA
3 split
bit 2:5 IF setup
bit 2 lo1/chI 0 298 MHz 1 290 MHz
bit 3 lo1/chII 0 298 MHz 1 290 MHz
bit 4 lo2/chI 0 84 MHz 1 78 MHz
bit 5 lo2/chII 0 84 MHz 1 78 MHz
Positive logic Note these values are integers
d_parbl |
||
Entry |
Value |
Introduced |
| 1 | Dump end year | |
| 2 | Dump end month | |
| 3 | Dump end days | |
| 4 | Dump end hours | |
| 5 | Dump end minutes | |
| 6 | Dump end seconds | |
| 7 | Integration time, sec | |
| 8 | Combined output power, W | |
| 9 | Elevation, degrees | |
| 10 | Azimuth, degrees | |
| 11 | Dump end time, secs since 1970 | |
| 12 | Dump sequence number | |
| 13 | % power tx1 klystron a (of 62.5 kW) | |
| 14 | % power tx1 klystron b | |
| 15 | % power tx2 klystron a | |
| 16 | % power tx2 klystron b | |
| 17 | % power tx3 klystron a | |
| 18 | % power tx3 klystron b | |
| 19 | % power tx4 klystron a | |
| 20 | % power tx4 klystron b | |
| 21 | Noise injection calibration, K | |
| 22 | Pre-integration factor | |
| 23 | % power tx5 klystron a | |
| 24 | % power tx5 klystron b | |
| 25 | % power tx6 klystron a | |
| 26 | % power tx6 klystron b | |
| 27 | % power tx7 klystron a | |
| 28 | % power tx7 klystron b | |
| 29 | % power tx8 klystron a | |
| 30 | % power tx8 klystron b | |
| 31 | rx frequency, channel 1 (MHz) | 1999-08-19 |
| 32 | rx frequency, channel 2 (MHz) | 1999-08-19 |
| 33 | rx frequency, channel 3 (MHz) | 1999-08-19 |
| 34 | rx frequency, channel 4 (MHz) | 1999-08-19 |
| 35 | rx frequency, channel 5 (MHz) | 1999-08-19 |
| 36 | rx frequency, channel 6 (MHz) | 1999-08-19 |
| 37 | rx frequency, channel 7 (MHz) | 1999-08-19 |
| 38 | rx frequency, channel 8 (MHz) | 1999-08-19 |
| 39 | rx frequency, channel 9 (MHz) | 1999-08-19 |
| 40 | d_parbl version number | 1999-11-12 |
| 41 | antenna ID (1-8) | 1999-11-12 |
| 42 | Remote antenna intersection range, m | 2003-02-28 |
| 43-62 | User parameters | 2003-07-23 |
| 63 | High voltage reading (V) | 2003-09-01 |
| 64 | Loop counter | 2004-02-01 |
| 65 |
ESR Peak power read from power meter (W) |
2004-02-20 |
| 66 |
ESR RF duty cycle calculated from RC binary |
2004-03-20 |
| 67 |
ESR SPEAR tx status |
2007-03-22 |
| 68 |
ESR LO settings |
2007-05-14 |
| 69 |
ESR CHI attenuator settings (dB) |
2007-05-14 |
| 70 |
ESR CHII attenuator settings (dB) | 2007-05-14 |
| 71 |
ESR Peak power in wave guide 32m antenna (kW) | 2008-05-24 |
| 72 |
ESR Peak power in wave guide 42m antenna (kW) | 2008-05-24 |
| 65 | UHF Peak power read from wave guide (W) | 2004-02-20 |
| 66 | UHF RF duty cycle read from wave guide | 2004-03-20 |
| 67 |
UHF Power status on Tromsø¸ systems |
2006-11-01 |
| 65 |
VHF antenna elevation panel 1 (deg) |
2005-05-21 |
| 66 |
VHF antenna elevation panel 2 (deg) | 2005-05-21 |
| 67 |
VHF antenna elevation panel 3 (deg) | 2005-05-21 |
| 68 |
VHF antenna elevation panel 4 (deg) | 2005-05-21 |
| 69 |
VHF IF system setup see note 1 |
2005-05-21 |
| 70 |
VHF Peak power read from wave guide (W) |
2006-10-30 |
| 71 |
VHF RF duty cycle read from wave guide |
2006-10-30 |
| 72 |
VHF Power status on Tromsø¸ systems | 2006-11-01 |
| 73 |
VHF CHI atennuator settings (dB) |
2008-04-21 |
| 74 |
VHF CHII atennuator settings (dB) | 2008-04-21 |
| 75 |
VHF Average power read in wave guide(kW) | 2008-12-11 |
